Titan Flow Control CV 12-CS Carbon Steel Short Pattern Wafer Type Swing Check Valve w/ Nitrile Rubber Seat & Seal - ASME Class 150
- Sizes: 2 - 8 in. - Larger sizes available - Please call for more information
- Type: Wafer - Single Disc - Short Pattern Design
- ASME Class: 150
- Body: Carbon Steel (A216 Gr. WCB)
- Seat & Seal: Nitrile Rubber
- Seat & Seal Temp. Range (Nitrile Rubber): -20 - 250°F
- ASME Class 150 Pressure/Temperature Rating: 275 PSI @ 100°F
- Low Cracking Pressure: 1/4 PSI
- Referenced Standards & Codes: API 598 B16.5 - Valve Testing; ASME B16.34 - Valves - Flanged, Threaded, & Welding End; ASME 150 - Flange Standard Conformity
- Markets: Oil & Gas Production, General Industry, Chemical & Petrochemical
- Wafer Style - Dual Plate Check Valve Installation - Operation - Maintenance Guide Pdf
Check valves are automatic shut-off valves that are commonly used for preventing backflow or drainage in a piping system. Often applied on the discharge side of pumps, check valves prevent the system from draining if the pump stops and protects against backflow, which could harm the pump and/or other equipment.
Note: This valve is intended for liquid service that is steady, clean (no abrasives or solids), and non-pulsating. Flow-rate must not exceed 15 ft/sec.